Drager Catalytic Bead DrägerSensor®

The DrägerSensor® ... DQ detects flammable gases and vapours such as hydrogen. Due to the double-detector compensation method, the catalytic sensor is particularly long-term stable. The wire mesh at the gas inlet serves as a flame barrier. So it ensures explosion protection at the same time short response time.

The catalytic bead principle
The DrägerSensors ... DQ are based on the catalytic bead detection principle. The most important component are the hot, catalytically active pearls on platinum coils (pellistors). These pellistors burn the gas and additional heat of reaction is created. The temperature increases depending on the gas concentration and thus also changes the electrical resistance of the platinum coils. This change is passed on as a measuring signal. There are five different catalytic bead sensors from Dräger, which are used in different transmitters and measuring heads.

DrägerSensor® PR M DQ
PR stands for poison resistant. The pellistors of the DrägerSensor PR M DQ have a longer service life under the influence of poisonous substances. The sensor has a metric thread (M) on the back.

DrägerSensor® PR NPT DQ
The DrägerSensor PR NPT DQ also withstands poisoning substances for a long time. This sensor is equipped with a NPT thread on the back.

DrägerSensor® HT M DQ
The DrägerSensor HT M DQ can be used at ambient temperatures of up to 155 ° C and is also approved accordingly (HT = high temperature). This sensor also has a metric thread.

DrägerSensor® LC M
LC stands for >low concentration<. The DrägerSensor LC M detects very low gas concentrations in the measuring range from 0 to 10% LEL. This is possible by a special arrangement of the PR pellistors, as well as an amplifier electronics. The sensor has a metric thread.

DrägerSensor® LC NPT
The LC NPT sensor also detects gas concentrations in the measuring range of 0 to 10% LEL. It is equipped with a NPT thread.

Download

Produk Lainnya

Drager VarioGard® Central Unit

The Dräger VarioGard® Central Unit is at the center of a cost-efficient, modular gas detection system. A digital Bus makes it possible to connect and manage up to 100 transmitters for various gases.

Drager VVP 1000

The Dräger VVP 1000 is a 10" touch panel that provides a clear and simple display of all data from your Dräger VarioGard® gas detector. The touch panel visualises all relevant information such as measurement values and status messages in a way that is well organised and easy to understand.

Drager PSD 3000

The Dräger PSD 3000 is a sampling unit for continuous sampling of gas and air mixtures. Combined with Dräger Gas Detectors, the Dräger PSD 3000 serves as a sampling system for gas monitoring purposes. The internal vibrating diaphragm pump has a superior life expectancy, due to the lack of rotating parts.

Drager PIR 3000

The Dräger PIR 3000 is an explosion proof infrared gas detector for continuous monitoring of combustible gases and vapors. Based on a stainless steel SS 316 enclosure as well as on a good measuring performance, this transmitter offers an excellent price-performance-ratio.

Drager Catalytic Bead DrägerSensor®

Informasi Pemesanan