Drager GS3

Locating leaks often proves to be very demanding due to locations that are difficult to access. This is where the Dräger GS3 leakage detector comes in: as it is no larger than a ballpoint pen, even hard-to-reach places are no problem. The detector for flammable gases such as natural gas, liquefied petroleum gas and hydrogen detects even the smallest of leaks, indicated by a visual and acoustic alarm signal.

Leak detector the size of a pen
Because the Dräger GS3 is the size of a ballpoint pen, it fits into any shirt pocket and can be easily stored and transported by the user. Its protective pouch also allows it to be easily attached to a belt and protects it against impacts.

Rapid leak detection
The handy Dräger GS3 is quick to respond to flammable gases such as natural gas, liquefied petroleum gas, methane, propane or butane. It reliably detects even the smallest leaks. For example, for methane the sensitivity is below 50 ppm with a detection range of 10,000 ppm. In addition to pipes, this also allows containers and closed circuits to be tested for leaks.

Alarm function
To ensure no alarm goes unnoticed, the Dräger GS3 also features a visual alarm with flashing LEDs, in addition to an acoustic signal.

Simple operation and handling
The Dräger GS3 is self-explanatory and easy to operate. Its light weight of only about 50 g makes it particularly comfortable to use.

No maintenance required
The Dräger GS3 calibrates itself automatically each time it is restarted. Since it calibrates itself automatically, maintenance is not necessary.

Simple operation
The Dräger GS3 is self-explanatory and very easy to use thanks to its 1-button operation and handy size. By rapprochement to a leak and increasing gas concentration, the flashing and ticking rate will increase. By removing from a leak and decreasing gas concentration the signals will become slower. If the concentrations become smaller, the measuring range is automatically adjusted. The Dräger GS3 switches off automatically after 10 minutes of idle time.

Leaks can also easily be detected in hard-to-reach places
Thanks to its small size, leakage locations can also quickly and easily be detected in hard-to-reach places.

Download

Produk Lainnya

Summitech BF4 BL(LC)

PRODUCT CODE : BF4 BL(LC)
COATING MATERIAL : Nitrile
LINEAR MATERIAL : Cotton Interlock
EXTERIOR FINISHING : Granular
CUFF STYLE : Extended sleeve with elastic edge
THICKNESS MM : N/A
LENGTH MM : 650mm ± 30mm
COLOUR : Blue
SIZE/WRIST : 9/L, 10/XL
PACKAGING : Bulk packed 12 pairs in a bundle 72 pairs in a master carton

Tuffsafe Mechanical Hazard Gloves, Black/Red, Nylon Liner, Nitrile Coating, EN388: 2003, 4, 1, 2, 1, Size 7

Protect the hands when handling greasy and oily components with Red Cut 1 safety gloves from Tuffsafe®. Colour-coded to indicate their medium protection level (level 1), these lightweight, breathable gloves offer excellent grip thanks to the nitrile foam palm coating.

Features and Benefits
• Seamless design to avoid skin irritation during prolonged use
• Knitted elasticated cuff for a secure fit
• Flexible to maintain dexterity

Standards
• CAT II
• EN388 4.1.2.1.

Warnings
• Not suitable for use in areas with a cut risk

Notes
• 13 gauge

Drager Pac® 8000

With the robust Dräger Pac® 8000, you'll be well equipped for tough conditions: this non-disposable, personal single-gas detection device is a reliable and precise instrument, which detects hazardous concentrations of 29 different gases, including special gases like NO2, O3 or COCl2. Measured data can easily be transmitted into the Dräger Gas Detection Connect system via Bluetooth®.

Drager X-act® 7000

The innovative Dräger X-act® 7000 analysis system consists of Dräger MicroTubes and an opto-electronic analysis device that lets you precisely measure gases in the low ppb range. It gives you precise results right on site, replacing slow, expensive lab analyses. It's extremely easy to use: insert the Dräger MicroTubes, start measuring, then read out the test result.

Drager GS3

Informasi Pemesanan