Safety & PPE

The Dräger VarioGard® Central Unit is at the center of a cost-efficient, modular gas detection system. A digital Bus makes it possible to connect and manage up to 100 transmitters for various gases.

Dräger RVP 7000 is a visualisation panel for data management and graphical representation of your Dräger REGARD® 7000 control system. Tables, alarm messages and icons provide an overview of measured values, and the statuses of gas warning systems. The panel is simple to operate using touch functions and gesture commands.

The Dräger FS-5000 is used to simulate the presence of fire or flames to test the correct operation of the Dräger Flame 5000 CCTV Detector.

The Dräger PSD 3000 is a sampling unit for continuous sampling of gas and air mixtures. Combined with Dräger Gas Detectors, the Dräger PSD 3000 serves as a sampling system for gas monitoring purposes. The internal vibrating diaphragm pump has a superior life expectancy, due to the lack of rotating parts.

The Dräger VVP 1000 is a 10" touch panel that provides a clear and simple display of all data from your Dräger VarioGard® gas detector. The touch panel visualises all relevant information such as measurement values and status messages in a way that is well organised and easy to understand.

The Dräger PEX 1000 is a converter module that converts the mV signals of the Dräger Polytron® SE Ex sensing heads into mA signals and sends them to a control unit like the Dräger REGARD® family. Together with the Dräger Polytron® SE Ex, the PEX 1000 fulfils the conditions set down for primary explosion protection.

The Dräger PIR 7000 is an explosion proof point infrared gas detector for continuous monitoring of flammable gases and vapours. With its stainless steel SS 316L enclosure and drift-free optics this detector is built for the harshest industrial environments, e.g. offshore installations.

The Dräger PointGard 2700 is a self-contained gas detection system for the continuous area monitoring of flammable hydrocarbon gases and vapors in ambient air. PointGard 2700’s rugged, water-resistant housing comes complete with a horn and strobes, a built-in power supply, and external relays. It is compatible with a remotely mounted Dräger PIR 7000 Type 334 or Type 340 infrared gas sensor.

The Dräger PIR 3000 is an explosion proof infrared gas detector for continuous monitoring of combustible gases and vapors. Based on a stainless steel SS 316 enclosure as well as on a good measuring performance, this transmitter offers an excellent price-performance-ratio.

The Dräger Polytron® SE Ex ... DQ sensing heads are gas detectors for the continuous monitoring of flammable gases and vapours in the ambient air. Measurement is based on the heat of reaction principle where a chemical reaction takes place in a catalytic bead (also known as a pellistor) inside the sensor.

The Dräger Polytron® 5700 IR is a cost effective explosion-proof transmitter for the detection of flammable gases in the lower explosive limit (LEL). It uses a high performance infrared Dräger PIR 7000 sensor that will quickly detect most common hydrocarbon gases. A 3-wire 4 to 20-mA analogue output with relays makes it compatible with most control systems.

The Dräger Polytron® 8200 CAT is an advanced explosion-proof transmitter for the detection of flammable gases in the lower explosion limit (LEL). It uses a catalytic bead DrägerSensor® Ex that will detect most flammable gases and vapours. In addition to a 3-wire 4 to 20-mA analogue output with relays it also offers HART®, Modbus and Fieldbus protocols, making it compatible with most control systems.