Pump & Lubricants
Kennedy Rotary Pump, 0.25L
RP250
Used for dispensing lubricants and disel, this cast iron pump with a steel suction tube and spout is the easy way to control the flow of said liquids. Suitable for container size of 200 litres, the pump possesses an inlet of 2" BSP and M59 x 5 male thread.
Features and Benefits
• Cast iron pump with steel suction tube and spout making for a hardy product
• Suited for use on a 200 lite capacity barrel
• With a 980mm tube to easily dispense liquids when necessary
Typical Applications
• Suited for controlling the flow of fluids in a 200 litre barrel
Used for dispensing lubricants and disel, this cast iron pump with a steel suction tube and spout is the easy way to control the flow of said liquids. Suitable for container size of 200 litres, the pump possesses an inlet of 2" BSP and M59 x 5 male thread.
Features and Benefits
• Cast iron pump with steel suction tube and spout making for a hardy product
• Suited for use on a 200 lite capacity barrel
• With a 980mm tube to easily dispense liquids when necessary
Typical Applications
• Suited for controlling the flow of fluids in a 200 litre barrel
Download
Produk Lainnya
Manufactured from 16 swg steel. Suitable for storing petrol. Suitable for storing and transportation of diesel, paraffin and motor oil. With lever type safety sealing cap and integral carrying handle. Painted outside and phosphated internally.
Features and Benefits
• Strong, ultra-durable material - made from 16 swg steel
• With lever type safety sealing cap and integral carrying handle
• Painted outside and phosphated internally
Notes
• UN Approved, Class 3
Features and Benefits
• Strong, ultra-durable material - made from 16 swg steel
• With lever type safety sealing cap and integral carrying handle
• Painted outside and phosphated internally
Notes
• UN Approved, Class 3
For use with Kennedy grease guns and all other hydraulic grease equipment.
Our horizontal multistage centrifugal pumps are made of multiple Discpacs, which feed into one another. These stages allow for higher levels of control over the output pressure.
Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.
Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost
Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)
Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot
Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost
Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)
Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot