Crosscut and double cut to improve control and chipbreaks. Manufactured from high grade tungsten carbide for general-purpose use. Suitable for deburring and polishing of cast iron, cast steel, carbon steel, alloy steel and stainless steel etc.
up to HRC65 hardness.

Features and Benefits
• Hard carbide construction for increased cutting hardness
• Crosscut and double for improved chip control and chipbreaks
• Suitable for deburring and polishing of materials up to HRC65 hardness

Typical Applications
• Deburring
• Polishing

Please note:
• Work piece and tools should always be steady and well supported
• Carbide burrs are not suitable for 'milling' large amounts of material, they are for light stock removal and high revolutions 'LOW FEED - HIGH SPEED'
• Always ensure that at least 70% of the shank length is clamped by the collet or chuck of the tool being used
• Always ensure that the tool is rated to the recommended operating speed of the burr

The HSS-Co 5% Countersink 6 Piece Set features high performance, multi flute countersinks in various sizes.

Features and Benefits
• Manufactured from high speed steel and cobalt for improved strength
• Straight shank design with bright finish for improved performance on ductile metals
• Supplied in a robust carry case for easy and secure portability
• straight shank design
• 90° ground flute angle provides optimal cutting performance with an inclusive angle of 90°

Standards
• Manufactured to BS328:Part 5:1983

Contents
• 1x 8, 10, 12.5, 16, 20 and 25mm

Typical Applications
Deburring
Chamfering

DCMT Turning Inserts

55° Rhombic Insert

Insert Grades QX520
(ISO P10-P35 M10-M30 K10-K30) Coated. An excellent general purpose grade for medium roughing on Steels, Stainless and Cast Irons.

Chip Breaker: PM. Application: Med Cut.

SPKN Milling Inserts

Square Insert

Insert Grade QP40
(P40) Uncoated. For rough medium and finish milling of tough Steels and Stainless Steels including interrupted cutting.